Smart Card Encoding

    Vernon Manufacturing

       Automatic Water Salesman

++ Please note:  This unit is no longer available. ++


ADDING OR SUBTRACTING MONEY FROM A SMART CARD


Your Mini-till is pre-programmed. Please do not attempt changes without contacting Vernon Manufacturing.


After the Mini-till is plugged in, it will run through a self-check and read “Log On Password”.


LOG IN:  Enter the password 0131. Please do not change this in case the unit needs to be sent in for repair.


After logging in, the display will read:  “Please Insert Card”. It will display the serial number of the card, profile, and purse. Press “Enter” until the unit reads “Balance”.


ADD MONEY to the card:  Enter the amount using the keypad; press “A” (Add); then “Enter”. The unit will process the card and show the new balance on the card. Remove the card.


DEDUCT MONEY from the card:  Enter the amount; press “D” (Deduct); then “Enter”. The unit will process the card and show the new balance on the card.


LOG OFF:  The encoder shuts down automatically after 15 minutes. If you need to log off early, press “CLR” (Clear) at the “Please Insert Card” prompt. At the “Log Off” prompt, press “1” (Yes), and “Enter”. Or simply unplug the unit. If you need further help, please call us at the number above.

Mail & Shipping:  712 Maple    Gypsum, KS  67448                               Proudly made in the USA

steve@vernonmfg.com      www.vernonmfg.com    P: 785.536.4412   F: 4452 - we prefer email